Filter
Top Products
Installing or removing drill bit or driver bit
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before installing or removing
the bit.
To
install the bit, place
it
in the chuck
as
far
as
it
will go. Tighten the chuck by hand.
Place the chuck key in each of the three
holes and tighten clockwise. Be sure to
tighten
all
three chuck holes evenly.
To
remove the bit turn the chuck key
counterclockwise in just one hole, then
loosen the chuck by hand.
Chuck
key
Tiahten
Switch action
Tool
speed
is
increased by increasing pres-
sure on the trigger.
To
start the tool, simply
pull the trigger.
Release
the trigger to stop.
For continuous operation, pull the trigger
and then push in the lock button.
To
stop
the tool from the locked position, pull the
trigger fully, then release
it.
CAUTION
:
Before plugging in the tool, always check to
see
that the trigger switch actuates properly
and returns to the "OFF" position when released.
6