Filter
Top Products
Holding
tool
When drilling
a
large diameter hole, hold the tool firmly with both hands.
Switch action
To
start the tool, simply pull the trigger.
Release
the trigger to stop.
Reversing switch action
This tool has
a
reversing switch to change
the direction of rotation. Slide the revers-
ing switch to the right for clockwise rota-
tion or to the left for counterclockwise.
Reversing
switch
CAUTION
:
Always check the direction of rotation before operation.
.Use the reversing switch only when the tool comes to
a
complete stop. Changing the
direction of rotation before the tool stops may ruin the tool.
Drilling operation
0
Drilling in wood
When drilling in wood, best results are obtained with wood drills equipped with
a
guide
screw. The guide screw makes drilling easier by pulling the bit into the workpiece.
To prevent the bit from slipping when startinga hole, make an indentation with
a
center-
punch and hammer
at
the point to be drilled.
Place
the point of the bit in the indenta-
tion and start drilling.
Use
a
cutting lubricant when drilling metals. The exceptions are iron and brass which
should be drilled dry.
0
Drilling in metal
7