Filter
Top Products
CAUTION
:
Pressing excessively on the tool will not speed up the drilling. In fact, this excessive pres-
sure will only serve to damage the tip of your bit, decrease the tool performance and
shorten the service life of the tool.
-There
is
a
tremendous force exerted on the tool/bit
at
the time of hole breakthrough.
Hold the tool firmly and exert care when the bit begins to break through the workpiece.
.A
stuck bit can be removed simply by setting the reversing switch to reverse rotation in
order to back out. However, the tool may back out abruptly if you do not hold
it
firmly,
0
Always secure small workpieces in
a
vise
or similar hold-down device.
Screwdr
iving operation
Place
the point of the driver bit in the screw head and apply pressure to the tool. Start
the tool.
Release
the switch trigger just
as
the screw bottoms out. If the switch trigger
is
not released, the screw may strip out the hole
or
the screw and/or bit may be damaged.
8