Filter
Top Products
*If you charge
a
battery cartridge from
a
just-operated tool or
a
battery cartridge which has
been left in
a
location exposed to direct sunlight or heat for
a
long time, the charging light
may flash in red color. If this occurs, wait for
a
while. Charging will begin after the battery
cartridge cools. The battery cartridge will cool faster if you remove the battery cartridge
from the fast charger.
*If the charging light flashes alternately in green and red color
a
problem exists and charg-
ing is not possible. The terminals on the charger or battery cartridge
are
clogged with
dust
or
the battery cartridge
is
worn
out
or
damaged.
*If you wish to charge two battery cartridge, allow 15 mimutes between charging on the
fast charger.
ASSEMBLY
Installing or removing driver bit or drill bit
CAUTl
ON
:
Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the bit
Hold the ring and turn the sleeve counter-
clockwise to open the chuck jaws. Place
the bit in the chuck as far as it will go. Hold
the ring firmly and turn the sleeve clock-
wise
to
tighten the chuck.
To remove the bit, hold the ring and turn
the sleeve counterclockwise.
When not using the driver bit, keep it in the
bit holders. Bits 45 mm (1-3/4") long can be
kept there.
Tighten
Slee
Ring
:ve
-
Bit
-
I
Bit holder
2
9