Filter
Top Products
Drilling operation
First, turn the adjusting ring
so
that the pointer on the adjusting ring points to
the
st-
marking. Then proceed
as
follows.
*Drilling in wood
When drilling in wood, best results are obtained with wood drills equipped with
a
guide
screw. The guide screw makes drilling easier by pulling the bit into the workpiece.
Drilling in metal
To
prevent the bit from slipping when starting
a
hole, make an indentation with
a
center-
punch and hammer
at
the point to be drilled place the point of the bit in the indenta-
tion and start drilling.
Use
a
cutting lubricant when drilling metals. The exceptions are iron and brass which
should be drilled dry.
CAUTION
:
*Pressing excessively on the tool will not speed
up
the drilling.
In
fact, this excessive
pressure will only serve to damage the tip of your bit, decrease the tool performance
and shorten the service life of the tool.
*There
is
a
tremendous force exerted on the tool/bit
at
the time of hole breakthrough.
Hold the tool firmly and exert care when the bit begins to break through the workpiece.
*A stuck bit can be removed simply by setting the reversing switch to reverse rotation in
order to back out. However, the
tool
may back out abruptly if
you
do not hold
it
firmly.
*Always secure small workpieces in
a
vise
or similar hold-down device.
Overload protector
The overload protector automatically cuts out to break the circuit whenever heavy work
is
prolonged.
Wait
20-30
seconds before resuming operation.
CAUTION
:
Always withdraw the tool from the workpiece before resuming operation. If the tool
cannot be withdrawn, hold the tool firmly when turning on the tool, to overcome
a
strong reaction.
Hook
A hook
is
provided
as
a
standard equip-
ment. This hook
is
convenient for tem-
porarily hanging the tool.
To
install the
hook, first insert one end of the hook into
one slot in the tool body and then insert
the other end into the other slot. Secure
the hook with the screw. The hook can be
installed on either left or right
side
of the
tool.
Hook
11