Filter
Top Products
Wiring diagram
P 8/12
Model 6411 (without Variable speed control and Reverse switch)
Machines Without Choke Coil
Switch
Field
Fig. D-2
Brush holder
boss A
boss B
Connecting Lead wire to Brush holder
1) Brush holders are not reversible
when assembled to Housing (L).
Terminal insertion hole of each
Brush holder must be positioned
outside boss A/boss B.
2) Do not route each Lead wire
inside boss A/boss B.
boss A
Terminal
Brush holder
boss B
Lead wire (black)
from No.2a Terminal of Switch
Field lead wire (black)
Route Field lead wire (white)
under Brush holder.
Route the following two Lead wires
between the ribs:
*Field lead wire (white)
*Lead wire (black)
from No.2a Terminal of Switch
to Brush holder
See "Connecting Lead wire to Brush holder".
See "Connecting Lead wire to Brush holder".
Put slack portion of Field lead wire (black)
in the space between Brush holder and
inside wall of Housing (L).
Power supply cord
Important: Do not put slack portion of any Lead wire in the space surrounded by Field and Brush holders.
Otherwise Lead wires will be broken by rotating Armature.