Filter
Top Products
11
Overload protector
The overload protector automatically cuts out to break the
circuit whenever heavy work is prolonged. Wait 20 - 30 sec-
onds before resuming operation.
Adjusting the fastening torque
The fastening torque can be adjusted infinitely from approx.
20 kg·cm (1.4 ft·lbs) to 80 kg·cm (5.8 ft·lbs). To adjust it,
loosen the two screws and turn the adjusting ring. Then
tighten the screws to secure the adjusting ring.
Refer to the table for relation between the numbers on the
adjusting ring and the fastening torque to be obtained.
Example:
35 kg·cm (2.5 ft·lbs) of fastening torque can be
obtained when the number 2 is aligned to the red
mark.
NOTE:
• Always tighten the two screws to secure the adjusting
ring after adjusting the fastening torque.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out any
work on the tool.
1. Red mark
2. Screw
3. Number
4. Adjusting ring
001755
2
3
4
1
001758
Numbers on
adjusting ring
1
2
3
4
5
Fastening torque to
be obtained
20 kg•cm (1.4 ft•lbs)
35 kg•cm (2.5 ft•lbs)
48 kg•cm (3.5 ft•lbs)
60 kg•cm (4.3 ft•lbs)
80 kg•cm (5.8 ft•lbs)