Filter
Top Products
12
Installing or removing socket
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before installing or
removing the socket.
Use 9.5 mm (3/8”) square drive socket which is very common
in the market.
To install the socket, push it onto the square drive of the tool
until it locks into place.
To remove the socket, simply pull it off.
OPERATION
Hold the tool firmly with both hands whenever possible and
place the socket over the bolt or nut. Then turn the tool on.
As soon as the bolt or nut becomes tight, the clutch will cut in
and the motor will stop automatically. Release the switch trig-
ger.
When fastening machine screws, use the proper screwdriver
bit shown in the figure. It is commonly available on the mar-
ket.
NOTE:
• Always use the correct size socket for bolts and nuts. An
incorrect size socket will result in inaccurate and
inconsistent fastening torque and/or damage to the bolt
or nut.
• Hold the tool with its square drive pointed straight at the
bolt or nut, or the bolt or nut will be damaged.
• If the motor will not start even after you pull the trigger,
release the trigger. Then pull the trigger again after
turning the socket slightly with your fingers.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out any
work on the tool.
001756
9.5mm(3/8”)
001757