Filter
Top Products
8
Adjusting the driving depth
Depress the stopper base as far as it will go. While keeping it
in this position, turn the adjusting knob until the bit tip
projects approx. 5 mm (3/16”) from the stopper base. Drive a
trial screw. If the screw head projects above the surface of
the workpiece, turn the adjusting knob in the A direction; if
the screw head is counter-sunk, turn the adjusting knob in
the B direction.
Installing screw strip
Insert the screw strip through the screw guide. Then insert it
through the feeder box until the first screw reaches the posi-
tion next to the driving position.
1. Stopper plate
2. Casing
3. Adjusting knob
A
B
1
2
3
5mm (3/16")
002665
1. Feeder box
2. Screw strip
3. Screw guide
1. Driving position
1
2
3
002666
1
002667