Filter
Top Products
0
When you charge
a
new battery cartridge or
a
battery cartridge which has not been used
for
a
long period,
it
may not acceqt
a
full charge. This
is
a
normal condition and does
not indicate
a
problem. You can recharge the battery cartridge fully after discharging
it
almost completely
a
couple of times.
0
If you wish to charge two battery cartridges, allow 15 minutes between chargings on the
fast
charger.
Removing
or
installing bit
CAUTION
:
Always be sure
that
the tool
is
switched off and the battery cartridge
is
removed before
removing or installing the bit.
To remove the bit, first pull the stopper
out of the locator.
Then grasp the bit with
a
pair of pliers and
pull the bit out
of
the magnetic bit holder.
Sometimes,
it
helps to wiggle the bit with
the pliers
as
you pull.
To install the bit, push the bit firmly
into the magnetic bit holder. Then install
the stopper by pushing it firmly into the
locator.
Depth adjustment
Loosen the screw and adjust the locator by
turning
it
to create
a
distance of approxi-
mately 1.5
-
2
mm (1/16”
-
5/64”)
from
the end
of
the stopper to the tip of the
bit. Tighten the screw to lock the locator.
Then, drive
a
trial screw into your material
or into
a
piece
of
duplicate material. Ob-
serve the depth
of
screw penetration into
the material. If the depth is not suitable for
the screw, continue adjusting until the
proper depth setting
is
obtained.
NOTE
:
Lock
rina
Stopper
Locator
Screw
\
Bit holder
Lock ring
1.5
mm
-
2
mm
I
(1116’‘
~
5/64”)
\
Locator
The locator will be locked by tightening the screw slightly.
Do
not tighten
it
excessively,
or
it
may be damaged.
7