Makita 6900D Impact Driver User Manual


 
IMPORTANT SAFETY INSTRUCTIONS
Length of Cord (Feet)
AWG Size of Cord
I.
SAVE THESE INSTRUCTIONS
-
This manual
contains important safety and operating instructions for battery charger.
2.
Before using battery charger, read all instructions and cautionary markings
on
(1)
battery charger,
(2)
battery, and
(3)
product using battery.
3.
CAUTION
-
To reduce risk of injury, charge only MAKITA Battery
9000.
Other types of batteries may burst causing personal injury and damage.
4.
Do not expose charger to rain or snow.
5. Use of an attachment not recommended or sold by the battery charger
manufacturer may result in a risk of fire, electric shock, or injury to persons.
6.
To reduce risk of damage to electric plug and cord,
pull
by plug rather than
cord when disconnecting charger.
7.
Make sure cord is located
so
that
it
will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
8.
An extension cord should not be used unless absolutely necessary. Use of
improper extension cord could result in a risk
of
fire and electric shock. If
extension cord must be used, make sure:
a. That pins on plug of extension cord are the same number, size, and shape
b. That extension cord is properly wired and
in
good electrical condition; and
c. That wire size is at least as large as the one specified in the table below.
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS
FOR
BATTERY CHARGERS
as those of plug on charger;
c
TABLE
1
25
50
100
150
18 18
18 16
9.
Do not operate charger with damaged cord or plug
-
replace them im-
mediately.
10.
Do
not operate charger if
it
has received a sharp blow, been dropped, or other-
wise damaged
in
any way; take
it
to a qualified serviceman.
11.
Do not disassemble charger or battery cartridge; take
it
to a qualified
serviceman when service or repair is required. Incorrect reassembly may
result
in
a risk of electric shock or fire.
12. To reduce risk of electric shock, unplug charger fro" outlet before attempt-
ing any maintenance or cleaning. Turning off controls will not reduce this risk.