Filter
Top Products
Installing or removing battery cartridge
Always switch off the tool before insertion
To
remove the battery cartridge, pull out
the
set
plate on the tool and grasp both
sides of the cartridge while withdrawing it
from the barrel.
To insert the battery cartridge, align the
tongue
on
the battery cartridge with the
groove in the housing and
slip
it
into
place. Snap the set plate back into place.
Be sure to close the set plate fully before
using the tool.
or removal of the battery cartridge.
Set
plate
I
/
Battery
cartridge
I
k
Do
not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it
is
not being inserted correctly.
Charging
Plug the fast charger into your power
source. Insert the battery cartridge
so
that
the plus and minus terminals on the bat-
tery cartridge are on the same sides
as
their
respective# markings on the fast charger.
Insert the cartridge fully into the port
so
that it rests on the charger port floor.
Press the start button (red). The charging
light will come on and charging will begin.
If the charging light does not come on,
press the reset button (yellow) first, then
the start button (red). If the charging light
Charging light
Start
button
tit\
goes out within
10
seconds even after pressing the reset button and start button
a
couple
of times, the battery cartridge
is
dead. (CAUTION
:
Wait for more than
5
seconds after
the charging light goes out to press the reset button again.) Replace
it
with
a
new one.
When the charging light goes oat after about one hour, you may remove the fully charged
battery cartridge.
After charging, unplug the charger from the power source.
CAUTION
:
Your new battery cartridge
is
not charged. You will need to charge
it
before use.
Do
not keep the button pressed in with tape, etc. or the circuit will not function pro-
perly. Also,
a
malfunction of the charger may result possibly causing overheating, etc.
If you try to charge
a
cartridge from
a
just-operated tool, sometimes the charging light
will not come on. If this occurs,
let
the cartridge cool off for
a
while. Then re-insert
it
and try
o
charge
it
once more.
1
6