Filter
Top Products
Insert the outer and inner
sleeves
into the tool while rotating the inner
sleeve
alternately
clockwise and counterclockwise until there
is
no gap between the outer
sleeve
and the
tool.
See the figure below. Then tighten the
two
screws securely.
Switch action
To start
the
tool, simply pull the trigger. Release the trigger to stop.
CAUTION
:
Before plugging in
the
tool, always check
to
see
that the trigger switch actuates proper-
ly and returns to the
“OFF”
position when released.
Bolt
installation
Slip the tool onto
the
bolt
so
that the inner
sleeve
completely covers
the
bolt
tip.
CAUTION
:
Be
careful when fitting the
sleeve
onto the
bolt tip.
Striking the tip can damage it
so
that it will no longer fit inside the
sleeve
properly.
Keep forward pressure on the tool while
sliding
it
further forward until the outer
sleeve
fits completely over the nut. If
the
tool
fails to fit completely over the nut,
twist the tool slightly right and left while
pushing forward.
sleeve
Pull the trigger switch. The outer
sleeve
turns to begin tightening the nut.
6