Filter
Top Products
CAUTION:
0
Always check the direction of rotation before operation.
*Use the reversing switch only after the tool comes to
a
complete stop. Changing the
direction of rotation before the tool stops may damage the tool.
Operation
Place the point of the driver bit in the screw head. Apply forward pressure to the tool to
the extent that the bit will not slip off the screw. Start the tool slowly and then increase
the speed gradually.
Release
the trigger just
as
the screw bottoms out. The proper fasten-
ing torque differs depending upon the kind or
size
of screws/bolts, the type of materials
to be fastened, etc. Refer to the figure below for the relation between fastening time and
wood screw size.
Seconds
6
5
1
Material to
be
fastend: Lauan
0
I
I I
I
I
03.8 04.0 04.2 04.5
mm
x
50 x65 x90 x120
Wood screw
/
Lag screw
size
NOTE
:
0
Use the proper bit for the head of the screw/bolt that you wish to use.
.When fastening machine screws in
a
steel
plate, the proper fastening torque can be
obtained in an extremely short time (approx.
0.1
-
0.2
seconds). Turn the tool off
as
soon
as
the impact sound
is
heard.
0
Hold
the tool pointed straight
at
the screw or the screw and/or bit may be damaged.
.When driving wood screws, predrill pilot holes to make driving easier and to prevent
splitting of the workpiece. The pilot holes should be slightly smaller than the wood
screws in diameter.
.The
size
of wood screw which can be fastened with this tool may differ depending upon
the type of material to be fastened. Always perform
a
test
operation to determine the
size
of wood screw.
.When fastening bolts or nuts, always perform
a
test
operation to verify the adequate
fastening time for your bolt or nut. Excessive fastening torque may damage the bolt/nut
or socket bit.
6