Makita 8270D Cordless Drill User Manual


  Open as PDF
of 5
 
Terminals
Repair
P 3 / 5
[2] Removal/Installation of Motor from/on Gear Assembly (cont.)
[3] Installing Speed change Lever
Fig. 6 Fig. 7
Fig. 5
Fig. 9 Fig. 10
Fig. 8
INSTALLATION
1) Place Motor bracket as illustrated in Fig. 5,
and fasten it to Motor with two Pan head
screws.
2) Aligning the protrusions on Motor bracket
with the grooves in Gear assembly,
assemble Motor to Gear assembly. (Fig. 6)
3) Assemble Motor to Gear assembly while
turning it in the clockwise direction when
viewed from the terminal end of Motor.
(Fig. 7)
1) Make sure that two Compression springs are set in place on Speed change lever
as illustrated in Fig. 8.
2) Install Speed change lever onto the protrusion on Gear assembly as illustrated
in Fig. 9.
After installation, slide Speed change lever to either side. (Fig. 10)
Protrusions on
Motor bracket
Grooves in Gear assembly
Motor
Motor
Motor bracket
Gear assembly
Gear assembly
Pan head screw
Protruding side
Motor
Motor bracket
Side without protrusion
Red marking
Speed change lever side
Trigger switch side
Place Motor bracket
so that its protruding
side is positioned on
the opposite side to the
red marking on Motor.
Compression
springs
Gear assembly Motor
Compression springs
Protrusion
Speed change
lever
Speed change lever
Protrusion
Speed change lever
 previous next