Filter
Top Products
11
CAUTION:
• Always set the speed change lever fully to the correct
position. If you operate the tool with the speed change
lever positioned halfway between the “I” side and “II”
side, the tool may be damaged.
• Do not use the speed change lever while the tool is
running. The tool may be damaged.
Selecting the action mode
This tool employs an action mode changing ring. Select one
of the three modes suitable for your work needs by using this
ring.
For rotation only, turn the ring so that the arrow on the tool
body points toward the mark on the ring.
For rotation with hammering, turn the ring so that the arrow
points toward the mark on the ring.
For rotation with clutch, turn the ring so that the arrow points
toward the mark on the ring.
CAUTION:
• Always set the ring correctly to your desired mode mark.
If you operate the tool with the ring positioned halfway
between the mode marks, the tool may be damaged.
Adjusting the fastening torque
The fastening torque can be adjusted in 16 steps by turning
the adjusting ring so that its graduations are aligned with the
arrow on the tool body. The fastening torque is minimum
when the number 1 is aligned with the arrow, and maximum
when the number 16 is aligned with the arrow.
Before actual operation, drive a trial screw into your material
or a piece of duplicate material to determine which torque
level is required for a particular application.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out any
work on the tool.
1. Action mode changing ring
2. Arrow
1
2
002419
1. Graduations
2. Adjusting ring
3. Arrow
1
2
3
002426