Filter
Top Products
14
Screwdriving operation
First, turn the action mode changing ring so that the arrow on
the tool body points to the marking. Adjust the adjusting
ring to the proper torque level for your work. Then proceed as
follows.
Place the point of the driver bit in the screw head and apply
pressure to the tool. Start the tool slowly and then increase
the speed gradually. Release the switch trigger as soon as
the clutch cuts in.
NOTE:
• Make sure that the driver bit is inserted straight in the
screw head, or the screw and/or bit may be damaged.
• When driving wood screws, predrill pilot holes to make
driving easier and to prevent splitting of the workpiece.
See the chart.
• If the tool is operated continuously until the battery
cartridge has discharged, allow the tool to rest for 15
minutes before proceeding with a fresh battery.
002450
Nominal diameter
of wood screw (mm)
3.1 mm (1/8”)
3.5 mm (9/64”)
3.8 mm (5/32”)
4.5 mm (11/64”)
4.8 mm (3/16”)
5.1 mm (13/64”)
5.5 mm (7/32”)
5.8 mm (7/32”)
6.1 mm (15/64”)
Recommended size
of pilot hole (mm)
2.0 - 2.2 mm (5/64” - 3/32”)
2.2 - 2.5 mm (3/32” - 3/32”)
2.5 - 2.8 mm (3/32” - 7/64”)
2.9 - 3.2 mm (7/64” - 1/8”)
3.1 - 3.4 mm (1/8” - 9/64”)
3.3 - 3.6 mm (1/8” - 9/64”)
3.7 - 3.9 mm (9/64” - 5/32”)
4.0 - 4.2 mm (5/32” - 11/64”)
4.2 - 4.4 mm (11/64” - 11/64”)