Filter
Top Products
0
Dust bag attachment
To
install the dust bag, fit the bag's
entry port onto the dust chute on the
right side of the sander, then
see
that the
small hole on the port fits over the pin
protruding from the chute by turning left
or right.
When removing the dust bag, turn the bag
to the left
to
slip the hole off the pin,
then simply pull off the dust bag.
commercial
abrasive paper of the
size
228 mm
(9")
x 280 mm
(1
1-1/16"1
may
be
used by cutting
it
in half.
Removing the frame cover
Remove from either the front or back
as
shown, when taking off the frame cover.
.-.
..
..
.-
..
-
.
..
.. .
..
,.
..
.
...
..
.:_
_.
..
'280
mm
(
11-1/16")
0
Regular emptying
of
dust bag
Regular emptying of the dust bag insures
the maximum suction force.
A
full bag
makes for ineffective dust collection.
0
Operation with coolant
This tool can be used to sand with waterproof paper and
a
coolant, but coolant should
never be allowed to enter the motor area. To use coolant, first remove the dust bag and
clean off any dust adhering to the tool.
Do
a
dry run for 2 or
3
minutes with the tool
held off the surface in order to remove dust adhering to the dust chute area. Then use
only enough coolant to
give
good operation
as
excessive coolant can easily be splashed
into the motor and markedly shorten motor life. Coolant may also bridge parts which
could result in
a
shock hazard.
4