Filter
Top Products
11
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take out
the worn carbon brushes, insert the new ones and secure
the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for
use with your Makita tool specified in this manual. The
use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding these
accessories, ask your local Makita service center.
• Wool bonnet 180 (Hook & loop)
• Backing pad 165 (Hook & loop)
• Abrasive discs
• Rubber pad 170
• Sanding lock nut 5/8 - 48
• Lock nut wrench 28
• Sleeve 18
• Grip 36
• Loop handle
1. Limit mark
1
001145
1. Screwdriver
2. Brush holder cap
12
003483