Filter
Top Products
6
9.
Do not leave the tool running. Operate the
tool only when hand-held.
10.
Do not touch the workpiece immediately
after operation; it may be extremely hot
and could burn your skin.
11.
Check that the workpiece is properly sup-
ported.
12.
Pay attention that the wheel continues to
rotate after the tool is switched off.
13.
This tool has not been waterproofed, so
do not use water on the workpiece sur-
face.
14.
Ventilate your work area adequately when
you perform sanding operations.
15.
Use of this tool to sand some products,
paints and wood could expose user to
dust containing hazardous substances.
Use appropriate respiratory protection.
SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety rules stated in this
instruction manual may cause serious personal injury.
SYMBOLS
USD101-2
The followings show the symbols used for tool.
V .......................volts
A.......................amperes
Hz .....................hertz
................alternating current
....................no load speed
.../min................revolutions or reciprocation per
minute
n
˚