Filter
Top Products
VOLTAGE WARNING: Before connecting the tool to a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified on the
nameplate of the tool.
A
power source with voltage greater than that specified
for the tool can result
in
SERIOUS INJURY to the user
-
as well as damage to
the tool.
If
in
doubt,
DO
NOT PLUG IN
THE
TOOL. Using a power source
with
voltage less than the nameplate rating is harmful to the motor.
ADDITIONAL SAFETY RULES
1.
Keep guards in place.
2.
Use only wheels having a maximum operating speed at least as high as
"No
Load RPM" marked on the tool's nameplate. When using depressed center
wheels, be sure to use only fiberglass-reinforced wheels.
3.
Check
the
wheel carefully for cracks or damage before operation. Replace
cracked or damaged wheel immediately.
4.
Use only flanges specified for this tool.
5.
Be careful not to damage the spindle, the flange (especially the installing
surface) or the lock nut. Damage to these parts could result in wheel
breakage.
6.
Hold the tool firmly.
7.
Keep hands away from rotating parts.
8.
Make sure the wheel is not contacting the workpiece before the switch is
turned on.
9.
Before using the tool on an actual workpiece, let
it
run for
a
while. Watch
for vibration or wobbling that could indicate poor installation or a poorly
balanced wheel.
IO.
Use the specified surface of the wheel to perform the grinding.
11.
Watch out for flying sparks. Hold
the
tool
so
that sparks fly away from you
12.
Do
not leave the tool running. Operate the tool only when hand-held.
13.
Do
not touch the workpiece immediately after operation;
it
may be extremely
and other persons or flammable materials.
hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
4