Filter
Top Products
Switch action
Slide the slide switch forward to start, and
the switch will lock in the "ON" position.
To
stop, lgihtly depress the rear of the
switch, and
it
will return to the
"OFF"
position.
CAUTION
:
Before plugging in the tool, always check
to
see
that the switch actuates properly
and returns to the
"OFF"
position when
depressed.
Operation
Hold the tool firmly. Turn the tool on and
then apply the wheel or disc to the work-
piece.
In general, keep the edge of the wheel or
disc
at
an angle of about
15"
to the work-
piece surface.
During the break-in period with
a
new
wheel, do not work the grinder in the
B
direction or
it
will cut into the workpiece.
Once the edge of the wheel has been
rounded off by use, the wheel may be
worked in both A and
B
directions.
Slide
switch
WARNING
:
0
It
should never be necessary to force the tool. The weight of the tool applies adequate
pressure. Forcing and excessive pressure could cause dangerous wheel breakage.
.Continued use of
a
worn-out wheel may result in wheel explosion and serious personal
injury. Depressed center wheel should not be used after
it
has been worn down to
90
mm
(3-1/2")
in diameter. Use of the wheel after this point
is
unsafe and
it
should be
removed from service and rendered unusable by intentional destruction.
6