Filter
Top Products
Installing
or
removing depressed center wheel
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before installing or removing
the wheel.
Lock
nut
Depressed
center wheel
Mount the inner flange onto the spindle.
Fit the wheel on over the inner flange and
screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft
lock firmly
so
that the spindle cannot re-
volve, then use the lock nut wrench and
securely tighten clockwise.
To
remove the wheel, follow the installation procedure in reverse.
Switch action
To start the tool, simply pull the trigger.
Release
the trigger to stop. For continuous
operation, pull the trigger and then push in
the lock button. To stop the tool from the
locked position, pull the trigger fully, then
release
it.
I
Lock
button
I------
Trigger switch
CAUTION
:
Before plugging in the tool, always check to
see
that the trigger switch actuates properly
and returns to the "OFF" position when released.
6