Filter
Top Products
10
TOOL
INSTALLATION
INSTRUCTIONS
AND USE
Selecting compressor
The air compressor must comply with the requirements of
ANSI B19.3 - 1981.
Select a compressor that has ample pressure and air output
to assure cost-efficient operation. The graph shows the rela-
tion between nailing frequency and compressor air output at
a compression of 8.5 kgf/cm²G (120 PSIG). Thus, for exam-
ple, when you drive about 10 nails 3.75 mm x 90 mm (0.148”
x 3-1/2”) per minute, a compressor with an air output over 55
l/minute is required. Pressure regulators must be used to
limit air pressure to the rated pressure of the tool where air
supply pressure exceeds the tool’s rated pressure. Failure to
do so may result in serious injury to tool operator or persons
in the vicinity.
NOTE:
• Nail size indicates diameter x length.
Selecting air hose
Use an air hose as large and as short as possible to assure
continuous, efficient nailing operation. With an air pressure of
5 kgf/cm²G (70 PSIG), an air hose with an internal diameter
of over 8.5 mm (5/16”) and a length of less than 20 m (6.6 ft.)
is recommended when the interval between each nailing is
0.5 seconds. Air supply hoses shall have a minimum working
pressure rating of 10.7 kgf/cm²G (150 PSIG) or 150 percent
of the maximum pressure produced in the system whichever
is higher.
CAUTION:
Low air output of the compressor, or a long or smaller
diameter air hose in relation to the nailing frequency may
cause a decrease in the driving capability of the tool.