Filter
Top Products
15
Depth gauge
The depth gauge is convenient for drilling holes of uniform
depth. Insert the depth gauge into the hole in the grip base.
Adjust the depth gauge to the desired depth and then tighten
the clamp screw to secure the depth gauge.
NOTE:
• The depth gauge cannot be used at the position where
the depth gauge strikes against the tool body.
Dust cup (optional accessory)
Use the dust cup to prevent dust from falling over the tool
and on yourself when performing overhead drilling opera-
tions. Attach the dust cup to the bit as shown in the figure.
The size of bits which the dust cup can be attached to is as
follows.
OPERATION
CAUTION:
• Always insert the battery cartridge all the way until it
locks in place. If you can see the red part on the upper
side of the button, it is not locked completely. Insert it
fully until the red part cannot be seen. If not, it may
accidentally fall out of the tool, causing injury to you or
someone around you.
• When operating overhead, always make sure the battery
cartridge is locked securely so that it will not be fallen out
of the tool. If not, it may accidentally fall out of the tool,
causing injury to you or someone around you.
1. Depth gauge
2. Clamp screw
3. Grip base
12
3
003179
1. Dust cup
1
003186
Dust cup 5
Dust cup 9
Bit diameter
6 mm (1/4”) - 14.5 mm (9/16”)
12 mm (15/32”) - 16 mm (5/8”)