Filter
Top Products
7
NOTE:
• The above figure shows standard applications. They
may differ under certain conditions.
Emptying dust bag
When the dust bag is about half full, switch off and unplug
the tool. Remove the dust bag from the tool. Then remove
the dust nozzle from the dust bag after unlocking the dust
nozzle by turning it slightly counterclockwise. Empty the dust
bag by tapping it lightly.
After emptying the dust bag, install the dust nozzle on the
dust bag. Turn the dust nozzle slightly clockwise to lock it in
place. Then install the dust bag on the tool as described in
’’Installing dust bag’’.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing abrasive disc
To install the abrasive disc, first remove all dirt or foreign mat-
ter from the pad. Then attach the abrasive disc to the pad,
using the hook-and-loop system of the abrasive disc and the
pad. Be careful to align the holes in the abrasive disc with
those in the pad.
CAUTION:
• Always use hook-and-loop system abrasive discs. Never
use pressure-sensitive abrasive discs.
1. Dust nozzle
1
002531
1. Dust nozzle
1
002532
1. Abrasive disc
1
002533