Filter
Top Products
*Always switch off the tool before inser-
tion or removal of the battery cartridge.
*To remove the battery cartridge, with-
draw it from the tool while pressing the
buttons on both sides of the cartridge.
*To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it until it is
locked with
a
little click.
Do
not use force when inserting the bat-
tery cartridge. If the cartridge does not
slide in easily, it is not being inserted cor-
rectly.
Installing or removing the saw blade
CAUTION:
*Always be sure that the
tool
is switched off and the battery cartridge is removed before
installing or removing the blade.
*Always clean out all chips or foreign matter adhering to the blade, blade clamp and/or
slider. Failure to do
so
may cause insufficient tightening of the blade, resulting in a seri-
ous injury.
To
install the blade, push the push button in the direction of the arrow and insert the blade
between the blade clamp and the slider as
far
as
it
will go. Then release the push button
and make sure that the blade cannot be extracted even though you
try
to pull
it
out.
CAUTION:
If you release the push button without inserting the blade deep enough, the blade may be
ejected unexpectedly during operation. This can be extremely dangerous.
To
remove the blade, push the push button in the direction of the arrow and pull out the
blade.
Blade
Push
button
-
Battery
c
0
10