Filter
Top Products
Repair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Gear assembly, Rotor, Stator assembly, Speed change lever assembly (cont.)
P 5/ 11
Fig. 18
Fig. 19
(4) Assemble Motor section with Gear assembly and Speed change lever assembly to Housing L at a time.
And assemble Switch and F/R change lever to Housing L. (Fig. 18) Then, assemble Housing R to Housing L.
(5) Assemble Rear cover to Housing set. (Figs. 19 and 9) and tighten nine PT3x16 Tapping screws to fasten Housing L,
Housing R and Rear cover.
Other side viewed from Housing L
Leaf spring (2 pcs.)
Speed change lever assembly
Make sure that two Leaf springs
are set in place in advance.
Depressions
Terminal of Stator must be on the center line of Motor section and Gear assembly.
Depression
in Rear cover
Protrusion on
Housing R
Fit the depression in Rear cover into
the protrusion on Housing R.
Fit the protrusions of Housing L
into the depressions of Stator
complete
F/R Change lever
Before assembling Switch to Housing L,
fit the prong of F/R change lever to
the projection of Switch.
prong portion
projection