Filter
Top Products
5
Lighting up the lamps
For Model
FS4200,FS4200A,FS4300,FS4300A,FS6200,FS6200A,
FS6300,FS6300A
1
009967
CAUTION:
• Do not look in the light or see the source of light
directly.
To turn on the lamp, pull the trigger. Release the trigger
to turn it off.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of lamp.
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
Reversing switch action
A
B
1
009962
CAUTION:
• Always check the direction of rotation before
operation.
• Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
This tool has a reversing switch to change the direction
of rotation. Move the reversing switch lever to
the
position (A side) for clockwise rotation or
the
position (B side) for counterclockwise rotation.
Hook
1
009963
The hook is convenient for temporarily hanging the tool.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing the bit
For model FS4000
To remove the bit, first remove the locator by pulling the
lock ring away from the gearhousing. Then grasp the bit
with a pair of pliers and pull the bit out of the magnetic bit
holder. Sometimes, it helps to wiggle the bit with the
pliers as you pull.
1
2
009964
To install the bit, push it firmly into the magnetic bit
holder. Then install the locator by pushing it firmly back
onto the gear housing.
1
3
2
4
010095
1. Locator
2. Bit
3. Gear housing
4. Magnetic bit
holder
1. Lock ring
2. Gear housing
1. Hook
1. Reversing
switch lever
1. Lamp