Filter
Top Products
6
For models
FS4200,FS4200A,FS4300,FS4300A,FS6200,FS6200A,
FS6300,FS6300A
To remove the bit, first move the locator by pulling the
lock ring away from the gear housing. Then keep
pushing the slide sleeve, which is a gold colored part of
the easy bit holder, toward the tool and pull the bit out of
the easy bit holder.
1
2
009964
1
2
3
009968
009969
To install the bit, push it firmly into the easy bit holder.
Then install the locator by pushing it firmly back onto the
gear housing.
009970
Use of locator holder
1
2
3
009971
The locator can be temporarily held on the locator holder
during replacing bit or using without locator. To hold the
locator, position the trapezoidal holes of the locator on
the swells of the locator holder and push it in.
OPERATION
009966
Fit the screw on the point of the bit and place the point of
the screw on the surface of the workpiece to be fastened.
Apply pressure to the tool and start it. Withdraw the tool
as soon as the clutch cuts in. Then release the switch
trigger.
CAUTION:
• When fitting the screw onto the point of the bit, be
careful not to push in on the screw. If the screw is
pushed in, the clutch will engage and the screw will
rotate suddenly. This could damage a workpiece or
cause an injury.
• Make sure that the bit is inserted straight in the
screw head, or the screw and/or bit may be
damaged.
• Hold the tool only by the handle when performing
an operation. Do not touch the metal part.
1. Swells
2. Trapezoidal
holes
3. Locator holder
1. Bit
2. Easy bit holder
3. Slide sleeve
1. Lock ring
2. Gear housing