Filter
Top Products
P 14/ 17
Fig. 34
[3]-9 Handle section
(1) Disassemble Handle section as per the left illustration in Fig. 29.
(2) Remove Handle cover by unscrewing 4x18 Tapping screw to replace the electrical parts in Handle. See Fig. 34.
Power supply cord
Remove 4x18 Tapping screw and Handle cover.
Switch and Power supply cord can be replaced.
Rubber pin 4 comes out after removing Switch.
4x18 Tapping
screw
Switch
Rubber pin 4
Handle cover
Repair
ASSEMBLING
Fig. 35
Fig. 36
Unscrew 5x25 Tapping screws. So Vibration absorbing handle can be disassembled in five parts as illustrated below.
(3) In case of HM0871C, the Vibration absorbing handle section can be disassembled as illustrated in Fig. 35.
Assemble Handle section as illustrated in Fig. 36.
Dust Cover
Support
Dust cover support
Assemble Dust cover support to Handle base, facing its Triangle mark to Back side.
When assembling Dust cover to Dust cover support, face the >NBS< mark to
Triangle mark on Dust cover support.
Dust cover
Dust cover
Handle
Handle
cover
5x25 Tapping
screw (2pcs.)
Flat washer 5 (2pcs.)
Handle base
Compression
spring 11
“>NBS<” Mark
Triangle mark
Back side