Filter
Top Products
ADDITIONAL SAFETY
RULES
1.
Wear a hard hat (safety helmet), safety glasses and/or face shield.
It
is also
highly recommended that you wear a dust mask, ear protectors and thickly
padded gloves.
2.
Be sure the bit is secured in place before operation.
3.
Under normal operation, the tool is designed to produce vibration. The screws
can come loose easily, causing a breakdown or accident. Check tightness
of screws carefully before operation.
4.
In cold weather or when the tool has not been used for a long time, let the
tool warm up for several minutes by operating
it
under no load. This will
loos-
en up the lubrication. Without proper warm-up, hammering operation is
difficult.
Be sure no one is below when using the tool in high locations.
5.
Always be sure you have a firm footing.
6.
Hold the tool firmly with both hands.
7.
Keep hands away from moving parts.
8.
Do
not leave the tool running. Operate the tool only when hand-held.
9.
Do
not point the tool at any one in the area when operating. The bit could
fly out and injure someone seriously.
IO.
When drilling or chipping into walls, floors or wherever "live" electrical wires
may be encountered,
DO
NOT TOUCH ANY METAL PARTS
OF
THE
TOOL!
Hold the tool by the insulated grasping surfaces to prevent electric shock
if
you drill or chip into a "live" wire.
11.
Do
not touch the bit or parts close to the bit immediately after operation;
they may be extremely hot and could burn your skin.
SAVE
THESE INSTRUCTIONS.
4