Filter
Top Products
9
Dust cover
CAUTION:
• Always wear safety goggles even when operating the
tool with the dust cover lowered.
Lower the dust cover to prevent chips from flying. However,
when making bevel cuts, raise it all the way.
Anti-splintering device (optional accessory)
For splinter-free cuts, the anti-splintering device can be used.
To install the anti-splintering device, move the base all the
way forward and insert it between the two protrusions of the
base.
NOTE:
• The anti-splintering device cannot be used when making
bevel cuts.
OPERATION
CAUTION:
• Always hold the base flush with the workpiece. Failure to
do so may cause blade breakage, resulting in a serious
injury.
• Advance the tool very slowly when cutting curves or
scrolling. Forcing the tool may cause a slanted cutting
surface and blade breakage.
Turn the tool on without the blade making any contact and
wait until the blade attains full speed. Then rest the base flat
on the workpiece and gently move the tool forward along the
previously marked cutting line.
1. Dust cover
002730
1
1. Anti-splintering device
2. Protrusions
1
2
002732
1. Cutting line
2. Base
1
2
002743