Filter
Top Products
19
2. Bevel angle
(1) 0° bevel angle
Push the carriage toward the guide fence and
tighten two clamp screws to secure the car-
riage. Lower the handle fully and lock it in the
lowered position by pushing in the stopper
pin. Loosen the lever at the rear of the tool.
Turn the 0° bevel angle adjusting bolt (lower
bolt) on the right side of the arm two or three
revolutions counterclockwise to tilt the blade
to the right.
Carefully square the side of the blade with the
top surface of the turn base using the triangu-
lar rule, try-square, etc. by turning the 0°
bevel angle adjusting bolt clockwise. Then
tighten the lever securely.
Make sure that the pointer on the arm point to
0° on the bevel scale on the arm holder. If it
does not point to 0°, loosen the screw which
secures the pointer and adjust the pointer so
that it will point to 0°.
(2) 45° bevel angle
Adjust the 45° bevel angle only after perform-
ing 0° bevel angle adjustment. To adjust left
45° bevel angle, loosen the lever and tilt the
blade to the left fully. Make sure that the
pointer on the arm points to 45° on the bevel
scale on the arm holder. If the pointer does
not point to 45°, turn the 45° bevel angle
adjusting bolt (upper bolt) on the right side of
the arm until the pointer points to 45°.
Adjusting the position of laser line
For model LS0714FL only
WARNING:
• As the tool is plugged when adjusting the position
of laser line, take a full caution especially at switch
action. Pulling the switch trigger accidentally cause
an accidental start of the tool and personal injury.
CAUTION:
• Never look into the laser beam directly. Direct laser
beam causes damage to your eyes.
• Never apply a blow or impact to the tool. A blow or
impact causes the incorrect position of laser line,
damage to the laser beam emitting part or a short
life of the tool.
1. Lever
2. Arm holder
3. 0 degree bevel
angle adjusting
bolt
4. Arm
5. Release button
1. Triangular rule
2. Saw blade
3. Top surface of
turn table
1. Bevel scale
2. Pointer
3. Screw
1
2
3
4
5
003943
1
2
3
001819
1
2
3
003944
1. Left 45 degrees
bevel angle
adjusting bolt
1. Work piece
2. Cutting line
3. Holder assem-
bly (optional
accessory)
1. Vertical vise
2. Holder assem-
bly (optional
accessory)
1
003945
1
2
3
005701
1
2
005702