Filter
Top Products
[9] Mounting turn base to base
1. Apply grease to slide plate and boss for accepting the turn base's axis. Refer to Fig. 2.
2. Fasten hex lock nut M8-13 so that the turn base can move smoothly without wobbling. Refer to Fig. 8-2.
[10] Mounting square rod and securing ring 26
1. Setting ring 26 to pipe 25-235 of arm holder complete, mount arm holder complete to turn base. See Fig. 9-1.
2. Slide arm holder complete so that each end of the two pipes come nearer to the axis of turn base. See Fig. 9-2.
3. Secure square rod to pipes of arm holder complete with hex bolt M5x30.
< Note > Rubber pin has to face
arm mounted side.
<Note>
For easy mounting, slide ring 26 closely
to arm mounted side in this step.
4. Slide ring 26 toward turn base and align the following holes for thumb screw M6x33 and hex socket head bolt M4x10.
* Screw hole of turn base (upper side)
* Screw holes of ring 26
* Screw hole of turn base (bottom side)
And tighten thumb screw M6x33 to secure ring 26 to turn base. See Fig. 9-3.
5. Tighten hex socket head bolt M4x10 from the bottom side of turn base.
Then ring 26 is completely secured to turn base.
Arm is mounted here.
Arm is mounted
here.
Fig. 9-1 Fig. 9-2
Fig. 9-3
Arm holder complete
Ring 26
Screw hole of ring 26
Screw hole of turn base (upper side)
Screw hole of turn base (bottom side)
Hex socket head bolt M4x10
Thumb screw M6x33
Pipe 25-235 of
arm holder complete
Ring 26
Arm holder complete
Turn base
Rubber pin
Axis of turn base
Hex bolt M5x30
Square rod
Hex bolt M5x30
Repair
P 10/ 26