Filter
Top Products
You may
wish
to add to
the
length of
the
fence by attaching an extra piece of wood.
Convenient holes are provided in the fence
for this purpose, and also for attaching an
extension guide (optional accessory).
I
I
NOTE
:
When planing, move the tool with the edge fence flush with the side of the workpiece.
Otherwise uneven planing may result.
Max. shiplapping depth
is
9
mm
(1
1/32").
Chamfering
To
make
a
cut
as
shown
at
the right, align the
"V"
groove in
the front base with the edge
of
the workpiece and plane
it
as
shown in the figure (A).
MA1 NTENANCE
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before attempting to perform
inspection or maintenance.
The tool will stop when the carbon brushes wear to
a
certain length. When this occurs,
both carbon brushes should be replaced.
To
maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and
replacement, any other maintenance of adjustment should be performed
by
Makita
Authorized or Factory Service Centers, always using Makita replacement parts.
9