Filter
Top Products
8
009881
To install a dust cover's brush, put the outer edge of the
dust cover's brush in the groove in the dust cover.
009882
And then expand the groove. With the groove being
expanded, insert the inner edge of the dust cover's
brush. Repeat this action and insert all the remaining
part.
Dust bag
1
009846
To install dust bag, slip onto dust port. Always make sure
to slip onto dust port all the way until it stops so that it
does not come off during operation.
Remove dust bag when it begins to touch cutting surface.
This is a sign that it is full. Failure to empty bag will lead
to poor suction/pickup.
Connecting a vacuum cleaner
009845
When you wish to perform clean planing operation,
connect a Makita vacuum cleaner to your tool as shown
in the figure.
OPERATION
010273
Always use the top grip (auxiliary handle) and firmly hold
the tool by top grip and switch handle during operations.
Planing in corners
For PC5000C
Flush planing of corners is possible after first removing
the dust cover cap.
For PC5001C only
1
2
3
4
009883
Before performing the flush planing of corners, remove
the hex bolt which secures roller holder and base holder
and then take away the whole roller holder.
Next, loosen the hex socket head bolt and take away the
dust cover cap and then adjust the dust cover in a
proper position according to your work.
1. Dust cover cap
2. The whole roller
holder
3. Hex socket head
bolt
4. Hex bolt
1. Dust bag