Filter
Top Products
Lubrication
CAUTION:
This servicing should be performed by Makita Authorized or Factory Service Centers only.
This tool required no hourly or daily lubrica-
tion because
it
has
a
grease-packed lubri-
cation system. It should be relubricated
after every
6
months of operation. Send the
complete tool to Makita Authorized or
Factory Service Center for this lubrication
service. However, if circumstances require
that you should lubricate it by yourself, pro-
ceed as follows.
Run the
tool
for several minutes to warm
it
up. Switch off and unplug the tool.
Loosen the six screws and remove the han-
dle. Note that the top screws are different
from other screws.
Disconnect the connector by pulling it
Remove the crank cap using
a
hex wrench.
Screws
-
Cramp capI
I
Hex
wrench
13