Filter
Top Products
Rest the tool on the table with the bit end pointing upwards. This will allow the old grease
to
collect inside the crank housing. Wipe out the old grease inside and replace with
a
fresh
grease
(60
9). Use only Makita genuine hammer grease (optional accessory). Filling with
more than the specified amount of grease (approx.
60
g) can cause faulty hammering
action or machine failure. Fill only with the specified amount of grease. Reinstall the crank
cap and tighten with the hex wrench.
Connect the connector and reinstall the handle.
Hammer grease
.
White
CAUTION:
Be careful not to damage the terminal or lead wires especially when wiping out the old
Do
not tighten the crank cap excessively.
It
is made of resin and is subject to breakage.
grease of installing the handle.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjust-
ment should be performed by Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
14