Filter
Top Products
Maintaining
Your
MAINTENANCE
WARNING:
For your own safety, push control knob
“OFF” and remove plug from power source outlet
before maintaining or lubricating your
saw.
General
An occasional coat of paste wax on the work table will allow
the wood being cut to glide smoothly across the work
surface.
Motor
If the power cord is worn, cut or damaged in any way, have it
replaced immediately.
Do
not attempt
to
oil the motor bearings or service the motor
internal parts.
0
n
Arm Bearings
Lubricate the arm bearings after
10
hours
of
use. Re-oil after
every
50
hours of use or whenever there is squeak coming
from the bearings.
METHOD
OF OILING BEARINGS
1.
Turn saw on its side.
2.
Squirt a generous amount of SAE20 Oil around the shaft
3.
Let the oil soak in overnight in this position.
4.
Next day repeat the above procedure
for
the opposite
end and bronze bearing.
side of the saw.
WIRING DIAGRAM
15