Filter
Top Products
To Change Nozzle Tip
Caution:
Allow applicator to cool to room temperature
before servicing. Failure
to do so may cause burns.
1. Remove nozzle by turning it counter-clockwise.
2. Insert new nozzle and turn clockwise. Do not overtighten.
Storage of Your PortaPro™ Glue Gun
1. Make sure the Fuel Flow Control is totally turned to the left
side and is firmly seated in the locked OFF position (Fig.7).
2. Stand the folding base to rest the glue gun and cool
the
nozzle, before storing or leaving unattended (Fig 8).
3. Store in proper location avoiding elevated temperatures and
away from children.
4. Leave tank approximately 1/2 full so lubrication of fuel pick-
up filter remains wet.
!
How to Empty Tank of Butane Gas if Needed
1. Only empty fuel tank in a well ventilated
area and away from ignition sources.
Remember butane is heavier than air.
2. Depress the filler valve at the back of
the tank with a small bladed screwdriver
and let the butane gas escape through
the small orifice opening. It takes approximately one minute for the butane
to escape from the tank. Be careful that the butane does not hit against your
fingers or hands. This could cause frostbite of the skin.
3. One method is to poke a small bladed screwdriver through a piece of paper
and then carefully depress the filler valve. The escaping gas will hit the paper
and not your hand.
4. Never turn gas lever to “ON” and allow gas to evacuate through the ejector/
tip. Doing this will clog the ejector and lead to premature failure.
5. Never try to unscrew the filler valve as it is adhesively bonded to the tank.
Breaking of this bond will destroy the unit, causing the tank to leak.
O
F
F
O
F
F
P
R
O
G
lu
e
G
u
n
0
T
M
O
F
F
A
B
O
F
F
O
F
F
O
F
F
P
O
R
T
A
P
R
O
B
u
t
a
n
e
P
o
w
e
r
e
d
G
l
u
e
G
u
n
GG-
10
0
T
M
P
O
R
T
A
P
R
O
B
u
t
a
n
e
P
o
w
e
r
e
d
G
l
u
e
G
u
n
GG-
10
0
T
M
P
OR
TA
P
RO
B
u
t
a
n
e
P
o
w
e
r
e
d
G
lu
e
G
u
n
G
G
-1
0
0
T
M
P
O
R
T
A
P
R
O
B
u
t
a
n
e
P
o
w
e
r
e
d
G
lu
e
G
u
n
G
G
-
1
0
0
T
M
7
8