Filter
Top Products
PROGRAMMING VCR CONTROL
NOTE: If you own a TV/VCR combination,skip this section and
perform “Programming TV/VCR Combo Control”on page 16.
Locate the brand name of your VCR in the Setup Codes For
VCRs section below, and write it in the following space.
VCR Brand: __________________________________
The brands are listed in alphabetical order with the most
popular codes listed first.You will use one of these codes
to program the Millennium 4 to operate your VCR:
1. Turn on your VCR and insert a video cassette.
2. On the Millennium 4,press VCR once. Press
and hold SETUP until the LED blinks twice,
then release SETUP.
3. Enter the first four-digit code for your VCR. If
you perform this procedure correctly, the LED
will blink twice.
NOTE: If the LED did not blink twice after entering
the code’s last digit, then repeat steps 2 through 3 and
try entering the same code again.
4. Aim the Millennium 4 at your VCR and press
POWER once.The VCR should turn off.If your
VCR remote control does not have a POWER
key, press PLAY.If the VCR does not respond,
repeat steps 2-3,trying each code listed for your
brand until you find one that works.If the VCR
still does not work ,try searching for the code
(see Searching For Your Code on page 26).
5. Write your VCR code in the boxes below for
future reference.
NOTE: Remember, to use the Millennium 4 to operate your VCR,
press VCR first.
Setup Codes for VCRs:
Admiral 0048
Adventura 0000
Aiko 0278
Aiwa 0037, 0000,0307
Akai 0041,0061,0106
American High 0035
Asha 0240
12
Millennium 4 Mnl M4094 2/29/00 6:21 PM Page 12