Filter
Top Products
ENGLISHen
12
used power tools must be collected separately and
handed in for environmentally compatible recycling.
Before disposal, discharge the battery pack in the
power tool. Prevent the contacts from short-
circuiting (e. g. by protecting them with adhesive
tape).
Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
U =Voltage of battery pack
B
L
=Sanding belt length
v
0
=Belt speed in idling
m =Weight with smallest battery pack
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a
h
=Vibration emission value (sanding
surfaces)
K
h
= Uncertainty (vibration)
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in EN
60745 and may be used to compare one tool with
another. It is also suitable for a provisional estimate
of the vibratory load.
The specified vibration level applies to the main
applications of the power tool. However, if the tool is
used for other applications, with different
accessories or is poorly maintained, the vibration
level may vary. This can considerably increase the
vibratory load over the entire working period.
An estimation of the level of exposure to vibration
should also take into account the times when the
tool is switched off or when it is running but not
actually doing the job. This can considerably reduce
the vibratory load over the entire working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organisation of work patterns.
A-effective perceived sound levels:
L
pA
=Sound pressure level
L
WA
=Acoustic power level
K
pA
, K
WA
= Uncertainty (noise level)
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!
Measured values determined in conformity with EN
60745.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
14. Technical Specifications