Filter
Top Products
4
ENGLISH
1.1 Specified Conditions of
Use
This dust collector is intended for the
extraction and collection of saw dust and
chips, which are generated when work-
ing wood or wood-derived materials.
Any other use is not as specified. Use
not as specified, alteration of the
machine or use of parts that are not
approved by the equipment manufac-
turer, can cause unforeseeable damage!
1.2 General Safety
Information
Read and follow also the instructions for
the woodworking machine connected to
the dust collector.
− Electrical hazard:
Operate the machine only on a
power source matching the following
requirements :
Protection against electric shock by
an residual-current device (RCD) of
30 mA sensitvity;
outlets properly installed, earthed
and checked.
Use only cables with at least
1.5 mm
2
lead cross-section.
Do not pull on power supply cable to
unplug.
− Hazard generated by machine
faults:
Do not operate the machine with a
faulty part. Replace damaged parts
at once! Do not make any changes
to the machine.
− Fire hazard:
Do not vacuum any hot objects (e.g.
chips generated by cutting metals).
− Hazard generated by uninten-
tional starting of the machine:
Unplug the dust collector before
emptying the dust bag.
Unplug when the dust collector is
not in use.
− Risk of injury by inhaling wood
dust:
Dust of certain timber species (e.g.
oak, beech, ash) can cause cancer
when inhaled. Wear a dust mask
when emptying the dust bag. Dis-
pose of the dust bag’s contents in an
ecologically safe way.
,
• Easily portable by pull-out handle
and two integrated wheels.
• Additional feet on one side to posi-
tion the dust collector in a upright
position to save floorspace.
1. Lift combination machine at the car-
rying frame (1) and place it on the
rubber feet on its side.
Caution!
Always lift the combination
machineat the carrying frame only!
2. Install further four rubber feet (2) on
the underside of the combination
machine.
3. Attach four rubber feet (3) to the
side of the dust collector.
4. Place combination machine on the
dust collector.
Risk of squashing between
combination machine and dust
collector!
5. Turn the small diameter suction
hose (4) appox. 10 mm into the
branch piece (5).
6. Fasten the branch piece (5) as illus-
trated with the connection hose (6)
and two hose clamps to the chip
case (7).
7. Slide the short suction hose
(100 mm ∅) (8) from below onto the
branch piece (5) and secure with a
hose clamp.
8. Fit support bracket (9) to the groove
(10) of the machine table and
secure with screws.
9. Remove cap (11) from the saw’s
blade guard (12).
1. Safety
2. Special Product Features
3. Assembly
1
2
3
4
5
8
6
7
9
10
11 12
XW0007E2.fm Operating Instruction ENGLISH