Filter
Top Products
Bolt front and rear crosshead plates (321x322)
to saw housing. Angle brackets with setting
screws "B" must point towards centre of
machine. Use 4 each hex. bolt M8x20, spring
washer B8.4 and hex. nut M8.
Place roller carriage extrusion (358) with both
brackets (319/320) onto crosshead plates. Scra-
pe off paint from slots of brackets if fit is very
tight. Secure bracket (319) to crosshead plate
with 1 each hex. bolt M6x16 and hex. nut M6.
Remove backstop plate (360) and place traver-
sing saddle (310) onto roller carriage extrusion
(358). Replace backstop plate.
User Responsibility
This genuine metabo accessory will perform in conformity with the description provided in this manual. It should
be checked periodically. Defective equipment should not be used. Parts that are broken, missing, plainly worn,
distorted or contaminated, should be replaced immediately. Should such repair become necessary, it is
recommend that such repairs are carried out by qualified persons approved by metabo or their representatives. The
user of this accessory shall have the sole responsibility for any malfunction which results from improper use or
unauthorized modification from standard specifications, faulty maintenance, damage or improper repair by anyone
other than qualified persons approved by metabo or their authorized representatives.
We reserve the right to change specifications without prior notificationand without obligation to backfit or supply
backfit parts or components.
2 Safety Instructions
- For model PKS 1500 the max. allowable workpiece weight resting on the table is 25 kg/55 lbs. More weight on
the sliding carriage can tilt the saw.
- For model PKS 2300 the max. allowable weight resting on the table is 35 kg/78 lbs. The support leg must be fitted
as described in 4 to prevent the saw from tilting.
GB
3 Assembly Instructions
Contents
1 Specifications
2 Safety Instructions
3 Assembly Instructions
4 Support (only for PKS 2300)
5 Maintenance and Servicing
6 Scale Setting
7 Setting of Riving Knife
8 Hints for Operation
9 Spare Parts List
10 Exploded View Drawing
Sliding Carriage PKS 1500 Sliding Carriage PKS 2300
Table Size 280 x 505 mm 280 x 505 mm
Max. capacity at 90° 610 mm 1260 mm
Max. capacity at 45° 1010 mm 1660 mm
Overall length 1500 mm 2300 mm
Max. Allowable weight on table 25 kg 35 kg
Stock-No. 091 000 3291 091 000 3321
1 Specifications