Filter
Top Products
Contents
1.0 Scope of Application
2.0 Specifications
3.0 User Responsibility
4.0 Standard Accessories
5.0 Optional Accessories
6.0 Assembly
7.0 Mitre Fence Assembly
8.0 Installation
9.0 Operation/Settings
10.0 Cutting
11.0 Saw Dust Collection (optional accessory)
12.0 Crane Lifting
13.0 Safety Rules
14.0 Care and Maintenance
15.0 Wiring Diagrams
16.0 Spare Parts List and Drawing
This machine will perform in conformity with the description contained in the instructions provided. This machine must
be checked periodically. Defective equipment (including service leads) should not be used. Parts that are broken,
missing, plainly worn, distorted or contaminated, should be replaced immediately. Should such repair or replacement
become necessary, it is recommended that such repairs are carried out by qualified persons approved by the equipment
manufacturer or its representative. This machine or any of its parts should not be altered or changed from standard
specifications. The user of this machine shall have the sole responsibility for any malfunction which results from
improper repair by anyone other than qualified persons approved by the equipment manufacturer or its representatives.
3.0 User Responsibility
2.0 Specifications
BKS 400/3.1 WNB BKS400/4.2 DNB BKS450/4.75DNB
Table size 1000 x 665 mm 1000 x 665 mm 1000 x 665 mm
Table height from floor 850 mm 850 mm 850 mm
Depth of cut 127 mm 127 mm 152 mm
Motor speed 50/60 Hz 2800/3360 rpm 2800/3360 rpm 2800/3360 rpm
Cutting speed 58.5 m/sec 58.5 m/sec 66 m/sec
Motor capacity P
1
S6 40% 3.1 kW 4.2 kW 4,75 kW
Motor capacity P
2
S1 100% 1.5 kW 2.1 kW 2.4 kW
Voltage 1~ 220/240V 3~ 380/440V 3~ 380/440V
Mains fuse 1 x 16A 3 x 16A 3 x 16A
Max. saw blade diameter 400 mm 400 mm 450 mm
Min. saw blade diameter 350 mm 350 mm 350 mm
Saw blade bore 30 mm dia. 30 mm dia. 30 mm dia.
Note: Saw blade 450mm diameter requires 4.75kW motor. Use of 450mm blades with 3.1kW and 4.2kW
motor voids factory warranty!
1.0 Scope of Application
This site saw model BKS 400/BKS 450 has been designed to perform rip and cross cuts in wood having a
square or rectangular cross section.
Cross cuts should only be performed with the help of the mitre fence.
Round stock or firewood should not be cut without an appropiate jig holding the work safely.
The maximum/minimum blade diameters are 400/350 mm for model BKS 400 and 450/350 mm for model
BKS 450.
-
-
-
-