Filter
Top Products
Attach mitre scale to segment using 3 each
tapping screw 3.9x9.5
washer 4.3
Place mitre fence segment onto carrier and
screw fitting bolt through segment into glide
piece.
Hardware:
fitting bolt SW 19x42
spring washer 12
plastic glide piece with threaded bush.
Place wave spring washer onto fitting bolt and
plastic glide piece into mitre fence carrier.
7.0 Mitre Fence Assembly
Bolt guide rod brackets to front and rear of
table. Use 4 each
hex. head bolt M8x16
hex. nut M8
Slide both plastic guide bushes onto guide rod,
then bolt guide rod to brackets. Use 2 hex.
head bolts M8x20.
Bolt mitre fence carrier to guide bushes. Use 8
raised countersunk tapping screws 4.8x22.
Install adjustable backstop on mitre fence seg-
ment. Hardware:
1 hex. head bolt M6x20
2 hex. nut M6
1 washer 6.4
Screw vernier scale to vernier scale carier with
2 each raised countersunk head tapping screw
2.9x6.5
Screw vernier scale carrier to mitre fence car-
rier with raised countersunk head tapping screw
4.8x13
Place guard support into guard support brak-
ket. Align with blade and riving knife and to
exact 90 against the table by moving the not
yet fully tightened guard support bracket. Tigh-
ten.
Note: An improperly set up guard support may
cause personal injury to the operator.
Install the hex. socket head screw holding the
push stick to the front left leg. Hardware:
1 hex. socket head screw M6x30
2 each hex. nut M6
Install bolt for holding the rip fence to front right
leg. Use hex. nut M8 and bolt M8
-
Cross cuts and mitre cuts must not be carried out without a suitable cross-cutting attachment (sliding carriage or
mitre fence).
If no mitre fence is installed use the Sliding Carriage stock-no. 091 000 06665.