Filter
Top Products
OM-230 298 Page 10
4-2. Adjusting Control Tilt Bracket
803 155
1 Tilt Bracket
2 Rear Pivot Screw
3 Front Screw
Loosen rear pivot screw. Remove
front screw. Pivot control down-
ward to desired viewing angle. Re-
place and tighten front screw. Tight-
en pivot screw.
1
2
3
4-3. Installing Boom And Reel Support
ST-142 596-C
1 Swivel Plates
2 Yoke
Remove hardware from swivel
plates and yoke.
3 Boom
Set boom into swivel as shown.
4 Yoke Pin
Install pin through yoke. Install cot-
ter pin and spread ends.
5 Bolt
Install bolt, tighten hardware, and
back bolt off one half turn.
6 Locking Knob
Install locking knob but do not
tighten.
7 Reel Support
Install reel support.
3
4
5
6
7
1
2
3/8, 3/4 in
Tools Needed: