Filter
Top Products
OM-211 076 Page 18
5-4. Program Push Button
1
3
Program
2
1 Program Display
The number of the active program
is displayed.
2 Program Push Button
3 Program Push Button LED
The LED lights to indicate that
programs can be changed using
the Adjust knob.
Momentarily press button to
illuminate LED. To change the
program number, rotate Adjust knob
to select one of eight programs.
Pressing and holding the push
button will display current wire size,
wire type and process.
To reset feeder to factory settings,
turn power source off for 10
seconds. Press and hold button in
on power up, wait until top display
shows RST and bottom display
shows NO before releasing button.
Feeder Set Up button LED will
begin flashing. Turn Adjust knob to
change bottom display to show
YES, then press Feeder Set Up
button to confirm selection. The top
display will show CYCL and the
lower display will show PWR. Turn
welding power source power off for
10 seconds, then turn power back
on again.
5-5. Upper Display
2
1
4
3
1 Upper Display
The upper display shows voltage or arc
length. The unit displays both preset voltage
or arc length and actual voltage. When
welding, actual arc voltage is displayed.
2 Upper Display Push Button
Press the button to illuminate the LED and
allow changing information in the display.
Release button to display voltage.
3 Upper Display Push Button LED
The upper display push button LED
illuminates to indicate that information
displayed can be changed by the Adjust
control.
4 Volts LED (Weld Voltage In MIG)
5 Arc Adjust LED (Pulse Mode)
The LEDs below the display illuminate to
indicate which value is being shown.
At any time while welding, the unit permits the
adjustment of the weld voltage and overrides
the display of actual arc voltage.
To activate Carbon Arc Cutting (CAC), press
and hold the upper display push button in on
power up. CAC will appear on the upper
display and NO will appear on the lower
display. Rotate adjust knob to YES on the
lower display, and press the flashing Feeder
Set up push button . CYCL will appear on the
upper display and PWR will appear on the
lower display. Turn welding power source off
and back on again to enable the Carbon Arc
Cutting process selection.
Volts Arc Adjust
5