Filter
Top Products
OM-228 322 Page 11
SECTION 4 − INTRODUCTION
4-1. Specifications
Type of Input
Power
Welding Power
Source Type
Welding
Circuit
Rating
IP
Rating
Overall
Dimensions
Maximum
Spool Weight
Wire Feed
Speed Range
Wire
Diameter
Range
Weight
24 Volts ac
Single-Phase
10 Amperes
50/60 Hertz
Constant
Voltage (CV)
DC With 14-Pin,
that Provides
Voltage and
100 Volts,
750 Amperes,
100% Duty
Cycle
IP 21 Length: 35 in
(889 mm)
Width: 21.5 in
(546 mm)
Height: 14 in
60 lb
(27 kg)
Standard
Speed: 50 to
1400 ipm (1.3
to 35.6 mpm)
.023 to 5/64 in
(0.6 to 2.0
mm)
83 lb
(37.6 kg)
Voltage and
Current
Feedback
Height: 14 in
(356 mm)
Low Speed:
20 to 400 ipm
(0.5 to 10.1
mpm)
.023 to 1/8 in
(0.6 to 3.2
mm)
93 lb
(42.2 kg)
If feeder is used with a welding power source that does not provide voltage and
current feedback through the 14-pin control cable, run-in will be disabled. Arc
voltage will not be displayed on feeders equipped with meters.
NOTE
SECTION 5 − INSTALLATION
Ref. 804 563-B
Y Do not put feeder where
welding wire hits cylinder.
Y Do not move or operate
equipment when it could tip.
1 Wire Feeder
2 Rubber Feet
Choose slot that allows all rubber
feet to sit securely on top of welding
power source.
3 Wire Spool/Reels
4 Gas Cylinder w/Hose And
Regulator (Customer
Supplied)
. Shielding gas pressure not to
exceed 100 PSI (689 kPa).
5 Welding Power Source
6 Running Gear
1
3
5
4
2
5-1. Site Selection
6
Wire feeder shown
is representative
only and does not
reflect actual unit.